Search Our Products
Contact Agent
varandis Email this agent

This set of arches (4 pieces) are made for the MITSUBISHI L200, third generation (1996–2005), double cabin. They have been modified to fit a truck with winch bumper.
They are made of good quality, hand-laid fiberglass and the surface is black gelcoat (smooth mat).  They stick out about 9 cm from the side of the vehicle. Make sure your car is the model described above and shown in the photos. If you are in doubt, send me a few photos of your car showing the front, sides and back. I will reply within a day and let you know if it’s the right model.
Each arch is installed by drilling and screwing 4 or 5 self tapping screws through the underside flange. The front and rear screw goes through the fiberglass, holding the ends of the flare snugly against the car wing flange, while the two or three in between are fitted through sheet metal strips which are fixed on the fiberglass, keeping the flare flange 2 to 3 cm lower than the car wing flange right above the wheel. This way you don’t have to put holes through the arch pockets and the sides of the vehicle, unless you want to. Another screw must go under the lower front end and the lower rear end of the flare (in total 6 or 7 screws for each arch). The clearing above the top of the flare flange allows the flare to be flushed on the inside with water so that it doesn’t collect mud and debris.
The arches are best installed by a professional or an experienced amateur.
We include the necessary screws, washers and rubber trim.

We ship from Cyprus (member of European Union). Parcels are sent by express or first priority airmail.

Every fiberglass product is made especially for you, after your order. The procedure takes a maximum of 10 business days. Usually, we are ready to ship within 7 to 8 working days. When the items are ready we package and ship them and email the tracking number to you, along with fitting instructions and a series of photos that will help your installer do a perfect installation job.

Gallery